Working with large dragons

Neolis · Post by **Neolis** » 11 Dec 2008, o 02:08

Hi all,
Looking for a bit of advice. I reciently recieved one of the large reaper dragons. I have everything filed away and unassembled but I am not sure on how to handle it while I am painting. The parts are neck and upper jaw, lower jaw, left and right body halfs, left and right wings, and rear leg loose. I am tempted to assemble and back the body and paint the rest seperate but I am honestly at a loss if this would be the best way of going about it. I would like to be handling the painted surfaces as little as possible. I would like to make this my winter project but need to get it in soon before it gets to cold to prime.

Thanks in advance,
Greg

Dargrin · Post by **Dargrin** » 11 Dec 2008, o 05:39

Most of the time I see people working them on a spike stuck in a cork. Small bit of green stuff to cover the hole.

Post by **Demi_morgana** » 11 Dec 2008, o 08:43

personally in most cases I assemble whole model beore painting it so the connections between sepatare parts are "hidden" as much as it's possible; besides there's always the risk of damaging painted element during assembling

not much constructive advice from me then

Post by **Nameless** » 11 Dec 2008, o 09:45

which dragon exactly do you have? I so love some of their dragons

As for your question - I tend to assemble all parts that do not hinder painting afterwards. I have never painted something as big as reaper dragon, mind you

Anyway, perhaps this article could be helpful: https://hot-lead.org/gallery/dragon/gauth.htm

ToMaZ · Post by **ToMaZ** » 11 Dec 2008, o 10:10

I do it just like Nameless and Demi. First I look if there are big gaps between different parts. If there are g, I assemble those parts first and fill the gaps. Then I consider the ease of painting with the different parts attached. If there are parts that really obscure some areas I'll paint those seperatly.

And for holding the fig I usually pin my large figs in a bigger piece of wood for easier handling, but it depends on the pose.

Neolis · Post by **Neolis** » 11 Dec 2008, o 13:57

I have Ebonwrath: https://www.reapermini.com/Miniatures/Bo ... test/10022

I was personally thinking of black scales highlighted out to a purple edge much like the old d&d manuals use to have it.

hmm I think I am going to have to come up with a base and pin every thing to it. I do have an extra tri-pod so that may be the trick I am looking for. I guess I am going to be playing mad scientist this weekend and trying to figure out how to get this done.

Post by **Nameless** » 11 Dec 2008, o 14:01

good luck

Post by **Demi_morgana** » 11 Dec 2008, o 14:06

and don't forget to bring us pics of finished mad-results

Post by **Skrit** » 11 Dec 2008, o 15:08

Big project! Curious how you'll handle it a i got a big mini too to paint and am also at a loss of where to start.

Seeing the pic I'd probably leave off the wings for now and attach them later.

Good luck mate and post lots of wip pics.

ToMaZ · Post by **ToMaZ** » 11 Dec 2008, o 17:32

Offtopic: Skrit, I know it's the big troll... give it to me I'll paint it for ya

On topic: that looks like a pretty big dragon. Take WIP pics please

The colorscheme sounds good. Fitting for a dark dragon.

Chest of Colors forum

Working with large dragons

Working with large dragons

RE: Working with large dragons

RE: Working with large dragons

RE: Working with large dragons

RE: Working with large dragons