Page 1 of 1
freehand painting....help!!!!!!!!
Posted: 21 Jun 2006, o 12:41
by davlin
hi all, i am new to chest of colors and after seeing some magnificent minis i am inspired to try freehand painting. i would sincerely appreciate some advice on this subject as i have tried it to very little success. surely there must be a few corner cutting tips. thanks all....davlin.
RE: freehand painting....help!!!!!!!!
Posted: 21 Jun 2006, o 12:48
by ToMaZ
hey hey, welcome to the boards
When I try freehands I do it like this: Draw the freehand design a couple of times on a piece of paper first. Then use a very diluted paint to build up the freehand on the area that you want it. Use a small brush with a good point. And keep the color of the underlaying surface nearby to correct any mistakes
Don't forget to take your time

Hope it helps.
Posted: 21 Jun 2006, o 12:54
by davlin
hi, many thanks for replying, am sure this tip works and will try it, thanks again my friend....davlin.
EDIT: I removed the double post
-ToMaZ-
Posted: 21 Jun 2006, o 13:37
by Django
Funny double post

.
It depends on what your are doing but sometimes its better to start with a black silhouette first!
uhm yeah keep your paint nice and wet, and practice is probably the best advice!
Posted: 21 Jun 2006, o 13:42
by endrem
I read somewhere a good tip (didn't try yet personally): Varnish the surface where you want to paint the freehand first, this way you'll have a protective layer on it. Paint the freehand on the varnished surface, so using some brush soap you'll be able to remove failed tries without harming the painting below

.
Posted: 21 Jun 2006, o 13:46
by ToMaZ
hehe yeah I've seen that tip on CMON I think... I might try that sometime soon

Posted: 21 Jun 2006, o 13:56
by mahon
that's what i sometimes do several times during painting - to protect what i've done in case i wanted to remove my later mistakes.
Posted: 21 Jun 2006, o 14:26
by LadyEyes
There's a
tutorial over at the Brush Thralls' site about painting symbols. It's for WM symbols, but the basic techniques of how to get shapes to come out might help you with some simpler things.
Posted: 21 Jun 2006, o 16:01
by Slawek
LadyEyes wrote:There's a
tutorial over at the Brush Thralls' site about painting symbols. It's for WM symbols, but the basic techniques of how to get shapes to come out might help you with some simpler things.
Me liked
Great tutorial!!!
Posted: 22 Jun 2006, o 22:14
by Dragyn
Thanks for the link LE, going to try this on the banner piece.
Mike