As the topic title suggests, I would like to know how do you guys make nice and smooth surface banners? I mean now alternative ways, like GS or other putty, not paper.
I'm planning to make a little banner for a figure and I tried to make it out of Green Stuff. I read somewhere once, that it helps to get the GS surface smooth and even if I press it on some kitchen film. This I have tried, it was better than with bare hands, but there were still some crinkles I couldn't remove.
Anyone has a good method to make it better? Any ideas are highly appreciated .
You can use metal (alluminium) foil, or GS - both give good effects
as for the method I use with GS - I will post some info from home...
generally it is that you use baking paper (covered with some water or some vaseline) put some GS on it and cover it with the paper again.
then you roll something over it to make it flat. after some time whan it's a bit cured you can take it, cut the shape and attach it to the mini. And add details later...
I was using a plastic bag, not like this from supermarket but one which had bigger thickness. I was just putting GS on it and than mowing the plastic making banner shape. After GS will get harden I was removing plastic and banner was finished.
To smooth surface I’m also using a dental tool cowered with some water or oil (vaseline).
I make my banners from metal cut out of cans. (beer cans, cola cans, hope you get what I mean...) It's very thin and you can bend it into shape very easily.
The can idea also sounds good. Isn't it a bit more sensitive than those made of GS?
GS stays a bit flexible, even after curing, that's why I rather tend to use that....
The only thing you have to be careful with (like all delicate places on a mini!) is that you don't bend it to much after it's been painted. Not because of the paint, which is always a bit flexibel, but because of the wrinkels that will get in the metal. It's very hard to get them out once they're in there!
.
