Hero Forge Palladin

This is the first miniature from Hero Forge that I had opportunity to paint. The figure was made from material called ‘Beta grey plastic’. There were no mould lines, as the mini was 3D printed, but there was a lot of tiny ‘pegs’ – remains of printing process that had to be removed. It was cast as one piece miniature, together with the square base. After priming the mini looked just like “normal” figure. The detail level is sufficient for gaming miniature.
The figure represents anti palladin in full plate armor casting a spell called “touch of corruption”.

3 thoughts on “Hero Forge Palladin”

  1. This was a piece I commissioned. JerzyK did an amazing job. It was a big hit at the table when I pulled it out. The detailing is top notch. Going to have many adventures with him.

    Thanks again!

Leave a Reply

Your email address will not be published. Required fields are marked *